Stand-Alone Alarms
Smartwares Stand-Alone Alarms
The system has pin code 1 2 3 4 when it is delivered. If you are not sure that the code has been changed, please check whether the system responds to 1 2 3...
Fri, 16 Oct, 2020 at 9:25 AM
Adding remote controls requires specific reprogramming, you will find below the complete procedure: Remote control learning: Press and hold the ...
Thu, 8 Oct, 2020 at 2:50 PM
Press Key Enter PIN code. Press down arrow until you see "Zone Setup", then press enter. Key in the number for the detector you wish to register...
Fri, 16 Oct, 2020 at 9:28 AM
A remote control must first be registered You can register a total of 6 remotes, 1 for ADMIN and 1 for each of the 5 USERS. The first remote control...
Fri, 16 Oct, 2020 at 9:22 AM
If you have lost a remote control, you can safely remove it from the system. 1: Press the button, then enter the administrator code and confirm with Ent...
Fri, 16 Oct, 2020 at 9:30 AM
PARTIAL ARM is a feature that allows you to turn on certain detectors while other detectors are not on For example, turn on magnetic contacts only when ...
Tue, 17 Aug, 2021 at 12:01 PM
Only in the test mode / walk test mode (DIP switch 1 in the SA68P on) the detector reacts immediately and lights up the LED of a motion detector during mov...
Tue, 17 Aug, 2021 at 12:02 PM
Only in the test mode / walk test mode (DIP switch 1 in the SA68P on) the detector reacts immediately and lights up the LED of a motion detector during mov...
Tue, 17 Aug, 2021 at 12:26 PM
To ensure that the alarm does not go off immediately when you enter, you switch per detector in de ZONE SET-UP een ENTRY DELAY in. We recommend that you ...
Tue, 17 Aug, 2021 at 12:25 PM