Press the P1 key on the motor

Press and hold the P1 key on the motor for approximately ± 2 seconds. Do not release until the LED indicator above the p1 key flashes.


TIP

If necessary, use the end of a paper clip to press the P1 key so that you can clearly see the LED indicator.


Press the P2 programming button on the remote control twice

Press P2 button on the back of the remote control twice within 3 seconds


TIP

If necessary, use the end of a paper clip to press the P2 button

Press the up button and the transmitter is ready for use.

Press the up button on the remote control. After this, the remote control is connected to the curtain track.


If the curtain moves the wrong way, repeat the above procedure and then press the other (down) button. Following the above procedure will erase all old transmitters from memory.